SENSIT - 100% output control

extend your senses

Rely on our sensors for 100 %

All the sensors that leave the SENSIT´s gate will pass an output check to be sure that they are delivered to you in guaranteed quality and are 100% reliable.

Learn more about the key stages of inspection that sensors go through from the moment they are leaving production to the moment they are packaged for you.

1. CYCLING

After manufacturing, all temperature sensors go to cycling chambers where they undergo 7 up to 10 temperature cycles from -10°C to 120°C depending on the sensor type. This is called the burn-in (or aging) process which simulates the load on the sensor in the application to detect critical manufacturing defects.

2. INITIAL CALIBRATION

This is followed by measuring the sensor at 0 °C by immersing it to crushed ice or at room temperature to check its functionality. Each sensor is compared with a reference sensor that has a direct link to the Czech Metrology Institute (CMI).

3. FINAL OUTPUT CONTROL

The last step is the final check to verify that there is no short circuit or moisture penetration into the sensor housing. This is done by measuring the insulation resistance between the sensor and the outer sensor housing. The final output check process determines whether the sensor meets the parameters we guarantee as a manufacturer.

You can therefore be sure that any critical sensor defects will be detected by us and we analyse it immediately to find the cause of the defect.

If you have any questions, we are here for you. Contact us at the phone number or e-mail address below.

SENSIT s.r.o. | Školní 2610 | Rožnov pod Radhoštěm 756 61 | Česká republika

T +420 571 625 571 | E obchod@sensit.cz